Racecraft Inc. 1982-1992 Camaro Steel Flat Camber Plates replace the stock rubber strut mount bushings with a spherical bearing allowing you full control of the suspension geometry.Though this kit can be used with or without a coil over kit, it is designed with a coil over application in mind.  Kit includes grade 8 hardware with Nickel plated and Black Flat Plates. They allow for easy maximum caster and  camber alignment. SOLD IN PAIRS.

• This is designed to have about 5 degrees of Caster angle. You will need to open up the top of the strut tower in order to acheive this. If you are going to be running a coil over kit the factory spring pocket on the frame will need to be removed.

Total Weight: 10.0 lbs

Complete Installation Instructions

Click Here

Strut Nut Options (MAKE SURE TO CHOOSE BELOW)

• RC80445 : 14mm-2.0 Camaro OEM Shaft Style Non Coil Over OEM Thread Pitch. Fits Camaro Lakewood Struts
• RC80446 : 14mm-1.5 Camaro OEM Shaft Style Non Coil Over Non-OEM Thread Pitch: KYB, Koni, Camaro Strange
• RC80447 :  Mustang- Santhuff / Strange / Menscer Coil Over Struts
• RC80448 : 5/8-18 Camaro Santhuff / Afco / Menscer Coil Over
• RC80449 : 14mm-2.0 Camaro OEM Shaft Style Coil Over - OEM Thread Pitch. Fits Camaro Lakewood 
• RC80450 : 14mm-1.5 Camaro OEM Shaft Style Coil Over Non-OEM Thread Pitch: KYB, Koni, Camaro Strange
• 340035: 14mm-2.0 Camaro OEM Shaft Style Coil Over - OEM Thread Pitch. Fits 2017 & Newer Camaro Viking Struts.

****When using these plates you may have to open the hole in the strut tower to allow for the bearing plate to clear****

*****If Using Mustang Struts You Must Use A Mustang Coil Over Kit*****

Spacer Kit Diagram

Click Here