1979-2004 Mustang ProLite 4130 Fab Housing

Starting at: $2,765.00

Racecraft's ProLite 4130 Fab Housing is built for the all-out racer looking to save as much weight as possible. Like the rest of our 79-04 Mustangs housings, it fixes a common problem with all the current fabricated housings on the market. The problem being that the upper control arm mounts are much higher than the stock location. The ProLite upper control arm has a "True Stock Hole Location" along with "One Hole Above and One Hole Below". These improved upper hole locations keep the upper arm angle from being severely angled downward. This is "key" when a lowered ride height is trying to be achieved.

The ProLite lower control arm bracket is another important ingredient to a lowered car ride height. This bracket offers 6 adjustment holes with 5 of them being lower than the factory location. This gives you many different bar intersect points to work with.

All Racecraft ProLite housings offer a 20lb weight savings over conventional designed housings, but does not sacrifice any of the brute strength Racecraft housings are known for. Every housing built is welded in a precision fixture to assure our customer the truest and straightest housing available. Only after the housing is completely welded, the faceplate is machined for a perfect fit when the center section is installed. All of our housings are 100% built in house to the customer's needs, with the same quality as all of our other hardcore racing parts. This is the strongest, straightest, and best engineered housing available for a true bolt in 9" fabricated housing.

Housing Features:

  • Smaller Panels & Surfaces Allow For The Use Of Thinner Materials
  • Extreme Compact Design
  • 40 Ounce Lube Capacity
  • 100% Tig Welded 4130 Chromoly Construction
  • 20Lb Weight Savings Over Conventional Designed Housings
  • 38Lb Bare Housing Weight
  • Housing Includes:

  • ARP Studs Kit
  • Filler Cap
  • Drain Plug
  • Axle Vent
  • Faceplate O-Ring
  • ProLite UCA BRKTS
  • ProLite LCA BRKTS
  • Custom LCA BRKT Width
  • Upper WBM
  • Shock MNT Holes:

  • Strange - 1/2" x 1"
  • Afco - 1/2" x 1"
  • Santhuff - (1/2" x 1" Standard) or 7/16" x 7/8"
  • Penske - (1/2" x 1" Standard) or 7/16" x 7/8"
  • JRI - (1/2" x 1" Standard) or 7/16" x 7/8"
  • QA1 - 7/16" x 7/8"
  • Link to Control Arm Spacer Layouts:

  • 1/2" & 5/8" Upper & Lower Control Arms

  • *Important Notes:

  • Housing is specifically designed for the Strange Ultra Case and Magnesium Case ONLY!!!
  • Dewco/Mark Williams/Moser/Standard Strange or any other carriers will not fit.
  • Inner Housing Gussets are required if making more than 1800HP

    Add to Cart:

    • Model: 211104

    Please Choose: